ccna guide

It is well known that 640-811 exam test is the hot exam of Cisco certification. Certinside offer you all the Q&A of the 640-811 real test . It is the examination of the perfect combination and it will help you pass 640-811 exam at the first time!

　
　
Exam : CISCO 640-811
Title : ICND


1. LAB
6. Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
Answer: B

2. Refer to the exhibit. What can be determined from the output shown?
A. The JaxSwitch1 switch is using VTP.
B. This is the only switch in the LAN topology.
C. The JaxSwitch1 switch is not the root switch.
D. The link to the root bridge is through a 1 Gbps connection.
E. Spanning Tree Protocol is disabled on the JaxSwitch1 switch.
Answer: C

3. Refer to the graphic. It has been decided that Workstation 1 should be denied access to Server1. Which of the following commands are required to prevent only Workstation 1 from accessing Server1 while allowing all other traffic to flow normally? (Choose two.)
A. RouterA(config)# interface fa0/0
RouterA(config-if)# ip access-group 101 out
B. RouterA(config)# interface fa0/0
RouterA(config-if)# ip access-group 101 in
C. RouterA(config)# access-list 101 deny ip host 172.16.161.150 host 172.16.162.163
RouterA(config)# access-list 101 permit ip any any
D. RouterA(config)# access-list 101 deny ip 172.16.161.150 0.0.0.255 172.16.162.163 0.0.0.0
RouterA(config)# access-list 101 permit ip any any
Answer: BC

4. Refer to the graphic. Which of the following commands would create the output shown at the bottom of the graphic?
A. Router# show ip eigrp topology
B. Router# show ip route
C. Router# show ip eigrp neighbors
D. Router# show ip ospf route
E. Router# show ip ospf database
Answer: A

5. What are the general recommendations regarding the placement of access control lists? (Choose two.)
A. Standard ACLs should be placed as close as possible to the source of traffic to be denied.
B. Extended ACLs should be placed as close as possible to the source of traffic to be denied .
C. Standard ACLs should be placed as close as possible to the destination of traffic to be denied .
D. Extended ACLs should be placed as close as possible to the destination of traffic to be denied .
Answer: BC

6. Refer to the exhibit. A network technician is troubleshooting a connectivity problem on R2. The technician enters the show cdp neighbors command at the R2 console. If the network is composed only of Cisco devices, for which devices should entries be displayed?
A. R1
B. SW-B and R1
C. SW-B, R1, and SW-C
D. R3, SW-B, R1, and SW-C
E. SW-A, R3, SW-B, R1, and SW-C
F. Host A, SW-A, R3, SW-B, R1, and SW-C
Answer: B

7. Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
Answer: B

8. Refer to the exhibit. What can be determined about the interfaces of the Main_Campus router from the output shown?
A. The LAN interfaces are configured on different subnets.
B. Interface FastEthernet 0/0 is configured as a trunk.
C. The Layer 2 protocol of interface Serial 0/1 is NOT operational.
D. The router is a modular router with five FastEthernet interfaces.
E. Interface FastEthernet 0/0 is administratively deactivated.
Answer: B

Certinside 640-811 Exam Features